The dense particles quickly sweep into a neat pile in the center of the bowl. Set the water into circular motion with one hand or a spoon. Partly fill the bowl with water and sprinkle dense particles such as sand or rice into the bowl. The effect of the secondary flow can be demonstrated using a circular bowl. The process of deposition of silt, sand and gravel on the convex bank is clearly illustrated in point bars. Gathering of erosion products near the concave bank and transporting them to the convex bank is the work of the secondary flow across the floor of the river in the vicinity of a river bend. This process can occur over a time from a few years to several decades, and may sometimes become essentially static. When deposition finally seals off the cutoff from the river channel, an oxbow lake forms. When this happens a new, straighter river channel develops-and an abandoned meander loop, called a cutoff, forms. The narrow neck of land between the two neighboring concave banks is finally cut through, either by lateral erosion of the two concave banks or by the strong currents of a flood. Continuous deposition on the convex bank and erosion of the concave bank of a meandering river cause the formation of a very pronounced meander with two concave banks getting closer. In contrast, both lateral erosion and undercutting occur on the cut bank or concave bank (the bank with the greater radius). In the vicinity of a river bend, deposition occurs on the convex bank (the bank with the smaller radius). When a river reaches a low-lying plain, often in its final course to the sea or a lake, it meanders widely. Because oxbow lakes are stillwater lakes, with no current flowing through them, the entire lake gradually silts up, becoming a bog or swamp and then evaporating completely. The entrances to the abandoned meander eventually silt up, forming an oxbow lake. The river then follows a shorter course that bypasses the meander. This takes place because meanders tend to grow and become more curved over time. Geology A meander develops into an oxbow lakeĪn oxbow lake forms when a meandering river erodes through the neck of one of its meanders. The word "oxbow" can also refer to a U-shaped bend in a river or stream, whether or not it is cut off from the main stream. In Australia, oxbow lakes are called billabongs. In South Texas, oxbows left by the Rio Grande are called resacas. The picture also shows that a third oxbow lake is probably in the making: the isthmus or bank in the centre of the most prominent meander is very narrow – much narrower than the width of the river eventually, the two sections of river on either side of an isthmus like that tend to break through and create a new, straighter course a new river bank then starts to accumulate, sealing off the meander and leaving another oxbow lake.Īn oxbow lake is a U-shaped lake or pool that forms when a wide meander of a river is cut off, creating a free-standing body of water. This picture of the Nowitna River in Alaska shows two oxbow lakes – a short one at the bottom of the picture and a longer, more curved one at the middle-right. For other uses, see Oxbow lake (disambiguation).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |